
Route the specified RF connection through multiple ports when the connected equipment supports this wiring layout.
Quick Specs
- Connector layout: 1 SMA female to 2 SMA male per cable
- Cable: RG316
- Listed length: 15cm (approximately 5.9in)
- Listed coaxial impedance: 50 Ohm
- Quantity: 2 Y-branch cable assemblies
- Three-port Y layout with standard SMA connectors.
- Short RG316 cable branches for routing between nearby connection points.
- Two complete cable assemblies per pack.
- Frequency range: Not specified for this assembly; confirm the operating band.
- VSWR: Not specified.
Compatibility
| Application | Compatibility requirements |
|---|---|
| Equipment interface | Match the connector families, genders and center contacts listed in Quick Specs. |
| Electrical requirements | Check the operating band, impedance and pin assignment of the complete connection. |
- Match all three connectors and check how the connected equipment is intended to share an RF path.
- Do not connect transmitter outputs together. Check the circuit design before attaching multiple active devices.
- This is a cable branch assembly. No isolation or matched power-divider specification is supplied; do not assume it provides those functions or boosts a signal.
Mechanical & Installation
- Check connector clearance and support attached cables during installation.
- IP Rating: Not specified. Protect exposed joints and cable entries as required by the installation.
Package Contents
- 2 SMA female-to-dual-SMA-male RG316 Y-branch cables.
Product reference: OL-4137-2X